Content of the material
ANSI Grade 1
ANSI stands for American National Standards Institute. They are a non-profit group that oversees the development of standards for a variety of industries. In order for a deadbolt to be considered commercial grade, it must meet the ANSI Grade 1 specification. This means that the deadbolt
- Has been tested to 250,000 open/close cycles
- Has a bolt that projects 1 inch into the door frame
- Can withstand 10 hammer blows without giving way
So many of us don’t think about security until it’s too late. Until someone has already broken into our home, mugged us on the street or hurt someone we love. The philosophy of Security Latest can be summed up in a single sentence: “Better safe than sorry!” I hope the security and safety information explained throughout our articles will help you keep dangerous situations at bay. – Editor in Chief, Peter Boné
2. Using a credit card
A credit card can be used for picking interior door locks, but it may damage some parts of the door. First, you need to make sure that the lock will not cause damage to the lock body or doorknob hardware. With some types of deadbolts, you have to remove the doorknob first to gain access to its pins and levers.
- Insert the credit card between the pins and levers on the lock so that it will not come in contact with any parts of the lock or doorknobs.
- Gently turn the lock up until you hear a click or feel resistance.
- Pull back on the latch to disengage and lift off the deadbolt from the door without damaging any door doorknob hardware or lock body parts.
Safe Tech Lessons
- How Combination Locks Work
- Changing Safe Combinations
- Changing Safe Combinations
- How to Crack a Safe
- How Safe Deposit Box Locks Work
- More Lessons Coming Soon
Where do you take your results for How To Pick A Deadbolt searching?
You can absolutely have peace of mind on our source of datum. Each of the data on our site is referred from the most reliable sources, from the experts about How To Pick A Deadbolt.
On each side of the door, mark the point 2-3/8″ or 2-3/4″ from the edge (the measurement depends on the length of your latch bolt; for specifics here, refer to the template provided by the manufacturer of your chosen lock). Meanwhile, on the edge of the door, mark the midpoint. The three marks you’ve made represent where you’re going to drill.
First up is the hole for the lock cylinder. Having attached the 2-1/8″ hole saw to your drill, address the mark on the front of door. Rather than drill all the way through, go about an inch deep, then move over and drill through the other side.
The result should be a clean, circular hole through which you can easily see the other side. Finish with the 1″ spade bit; drill through the marked point on the side of the door, continuing until this hole meets the other.
Underwriters Laboratories is another well-known organization that tests products and writes standards. UL 437 is the standard for high-security locks accepted across the security industry. In order to pass the UL 437 test, locks must resist a variety of attacks including drilling, picking, prying, etc.
How many results will be given for the search of How To Pick A Deadbolt?
It depends on the time you search How To Pick A Deadbolt. Usually, the most effective solution will be prioritized, however, in case we suppose that users should have more options, there will be more than one choice.